Brother International Innov-is NQ1300PRW Operation Manual - Page 102
Scallop stitching, Smocking
View all Brother International Innov-is NQ1300PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Decorative Stitching Scallop stitching The wave-shaped repeated pattern that looks like shells is called "scalloping". It is used on the collars of blouses and to decorate the edges of projects. Attach monogramming foot "N". a Sew parallel stitching at intervals of 1 cm (3/8 inch). c 1 Select stitch . b Stitch along the edge of the fabric, making sure not to c sew directly on the edge of the fabric. 1 1 cm (3/8 inch) • Do not use reverse/reinforcement stitching or thread cutting. • At the end of the stitching, the thread is pulled out about 5 cm (2 inches). Pull the bobbin threads to create gathers. d Smooth the gathers by ironing them. • For better results, apply spray starch onto the fabric and press with a hot iron before it is sewn. Trim along the stitches. d Select stitch , or . e Stitch between the straight stitches. f • Be careful not to cut the stitches. Smocking The decorative stitch created by stitching or embroidering over gathers is called "smocking". It is used to decorate the front of blouses or cuffs. The smocking stitch adds texture and elasticity to fabric. Attach zigzag foot "J". a J Pull out the threads for the straight stitches. g Select the straight stitch, and then adjust the stitch b length to 4.0 mm (3/16 inch) and loosen the thread tension. • For details, refer to "Setting the stitch length" and "Setting the thread tension" in the "Basic operations" section. • For details, refer to "Pulling up the bobbin thread" in the "Basic operations" section. S-42