Brother International Innov-is NQ1300PRW Operation Manual - Page 40
Removing and attaching the presser foot, holder
View all Brother International Innov-is NQ1300PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Replacing the Presser Foot Note • When a stitch is selected, the icon for the presser foot that should be used appears in the screen. Check that the correct presser foot is attached before starting to sew. If the wrong presser foot is installed, turn off the machine, attach the correct presser foot, turn machine back on and then select the desired stitch again. ■ Attaching the presser foot holder Raise the presser foot lever. a Align the presser foot holder with the lower-left side of b the presser bar. Zigzag foot "J" Monogramming foot "N" Overcasting foot "G" Buttonhole foot "A" Blind stitch foot "R" Button fitting foot "M" Side cutter "S" • For details on the presser foot that should be used with the selected stitch, refer to "Stitch Setting Chart" on page B-46. Hold the presser foot holder in place with your right c hand, and then tighten the screw using the screwdriver in your left hand. Turn the screw toward you (clockwise). 1 1 Screwdriver Removing and attaching the presser foot holder Remove the presser foot holder when cleaning the machine or when installing a presser foot that does not use the presser foot holder, such as the walking foot and quilting foot. Use the screwdriver to remove the presser foot holder. Remove the presser foot. a • For details, refer to "Replacing the presser foot" on page B-31. Use the screwdriver to loosen the presser foot holder b screw. Turn the screw toward the back of the machine (counterclockwise). • The presser foot holder screw can also be loosened or tightened with the L-shaped (or disc-shaped) screwdriver. CAUTION • Be sure to securely tighten the presser foot holder screw, otherwise the presser foot holder may fall off and the needle may strike it, causing the needle to bend or break. Note • If the presser foot holder is not correctly installed, the thread tension will be incorrect. 2 13 1 Screwdriver 2 Presser foot holder 3 Presser foot holder screw B-32