Brother International Innov-is NQ1300PRW Operation Manual - Page 73
Raise the presser foot lever to check that the side
View all Brother International Innov-is NQ1300PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Remove the presser foot. a Hook the connecting fork of the side cutter onto the b needle clamp screw. a Overcasting Stitches Select a stitch. f Make a cut of about 2 cm (3/4 inch) long in the fabric g at the beginning of the stitching. 1 b 1 Connecting fork 2 Needle clamp screw Position the side cutter so that side cutter pin is aligned c with the notch in the presser foot holder, and then slowly lower the presser foot lever. 1 2 cm (3/4 inch) Position the fabric in the side cutter. h The cut in the fabric should be positioned over the guide plate of the side cutter. S UTILITY STITCHES b a 1 Notch in presser foot holder 2 Pin Note • When it is hard to set under the presser foot holder, fit the pin on the side cutter into the notch of the presser foot holder raising up the presser foot lever higher. Raise the presser foot lever to check that the side d cutter is securely attached. Pass the upper thread under the side cutter, and then e pull it out toward the rear of the machine. a 1 Guide plate • If the fabric is not positioned correctly, the fabric will not be cut. Lower the presser foot lever, and then start sewing. i → A seam allowance is cut while the stitching is sewn. • If the stitching is sewn in a straight line , the seam allowance will be about 5 mm (3/16 inch). 1 1 5 mm (3/16 inch) Memo • The side cutter can cut as much as one layer of 13-oz. denim. • After using the side cutter, clean it by removing any lint or dust. • If the side cutter can no longer cut fabric, use a piece of cloth to apply a small amount of oil to the cutting edge of the cutter. Sewing S-13