Brother International Innov-is NQ1300PRW Operation Manual - Page 131
remove the bobbin from the shaft and cut the thread
View all Brother International Innov-is NQ1300PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
If the thread become tangled under the bobbin winder a seat, press the "Start/Stop" button once to stop the bobbin winding. When the foot controller is plugged in, remove your foot from the foot controller. Cut the thread with scissors beside the bobbin-winding b thread guide. 1 1 Bobbin-winding thread guide Slide the bobbin winder shaft to the left, and then c remove the bobbin from the shaft and cut the thread leading to the bobbin in order to be able to completely remove the bobbin from shaft. Hold the thread end with your left hand, and wind off d the thread clockwise with your right hand as shown below. Troubleshooting A MAINTENANCE AND TROUBLESHOOTING Wind the bobbin again. e Note • Make sure that the thread passes under the pretension disk of the bobbin-winding thread guide correctly. Appendix A-11