Brother International Innov-is NQ1300PRW Operation Manual - Page 128
Fabric is caught in the machine and cannot, be removed
View all Brother International Innov-is NQ1300PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Troubleshooting Fabric is caught in the machine and cannot be removed If the fabric is caught in the machine and cannot be removed, the thread may have become tangled under the needle plate. Follow the procedure described below to remove the fabric from the machine. If the operation could not be completed according to the procedure, instead of attempting to complete it forcefully, contact your nearest Brother authorized service center. ■ Removing the fabric from the machine Immediately stop the machine. a Turn off the machine. b Remove the needle. c If the needle is lowered into the fabric, turn the handwheel away from you (clockwise) to raise the needle out of the fabric, and then remove the needle. • Refer to "Replacing the needle" in the "Basic operations" section. Remove the presser foot and presser foot holder. d • Refer to "Replacing the presser foot" and "Removing and attaching the presser foot holder" in the "Basic operations" section. Lift up the fabric and cut the threads below it. e If the fabric can be removed, remove it. Continue with the following steps to clean the race. Remove the needle plate cover. f Remove the bobbin case. h If threads remain in the bobbin case, remove them. 1 Bobbin case Use the cleaning brush or a vacuum cleaner to remove i any lint or dust from the race and its surrounding area. 1 Cleaning brush 2 Race If the fabric could be removed. Continue with step p. If the fabric could not be removed. Continue with step j. Use the included L-shaped (or disc-shaped) j screwdriver to loosen the two screws on the needle plate. 1 1 Needle plate cover • Refer to "Cleaning the race" on page A-2. Cut out the tangled threads, and then remove the g bobbin. Note • Be careful not to drop the removed screws in the machine. Slightly lift up the needle plate, cut any tangled k threads, and then remove the needle plate. Remove the fabric and threads from the needle plate. A-8 If the fabric cannot be removed, even after completing these steps, contact your nearest Brother authorized service center.