Brother International Innov-is NQ1300PRW Operation Manual - Page 43
Sewing a stitch
View all Brother International Innov-is NQ1300PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Sewing a stitch Turn the main power to ON and push a position button) to raise the needle. (Needle Select the desired stitch following the procedure b described in "Selecting a stitch pattern" above. If necessary, specify the setting for automatic reverse/ c reinforcement stitching and adjust the stitch length, etc. • For details on adjusting the stitch width and length, refer to "Setting the stitch width" on page B-39 and "Setting the stitch length" on page B-39. Note • When a stitch is selected, the icon for the presser foot that should be used appears on the screen. Check that the correct presser foot is attached before starting to sew. If the wrong presser foot is installed, turn off the machine, attach the correct presser foot, turn machine back on and then select the desired stitch again. Install the presser foot. d • For details on changing the presser foot, refer to "Replacing the Presser Foot" on page B-31. CAUTION • Always use the correct presser foot. If the wrong presser foot is used, the needle may strike the presser foot and bend or break, possibly resulting in injury. Refer to page B-46 for presser foot recommendations. Set the fabric under the presser foot. Hold the fabric e and thread with your left hand, and rotate the handwheel counterclockwise or press (needle position button) to set the needle in the sewing start position. Sewing Lower the presser foot. f You do not have to pull up the bobbin thread. Adjust the sewing speed with the sewing speed g controller. You can use this controller to adjust sewing speed during sewing. B STARTING TO SEW b a 1 Fast 2 Slow Press the "Start/Stop" button to start sewing. h Guide the fabric lightly by hand. Memo • When the foot controller is being used, you cannot start sewing by pressing the "Start/Stop" button. Press the "Start/Stop" button again to stop sewing. i Press the (Thread cutter button) to trim the upper j and lower threads. Memo • The black button on the left side of presser foot "J" should be pressed only if the fabric does not feed or when sewing thick seams. For details, refer to "Sewing thick fabrics" in the "Sewing" section. Normally, you can sew without pressing the black button. 1 1 Thread cutter button → The needle will return to the up position automatically. Basic operations B-35