Brother International Innov-is NQ1300PRW Operation Manual - Page 123
If there is a screw in the needle plate cover, If there is no screw in the needle plate cover
View all Brother International Innov-is NQ1300PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
■ If there is a screw in the needle plate cover 1 Use the L-shaped (or disc-shaped) screwdriver to remove the screw in the needle plate cover. Care and Maintenance Insert the bobbin case so that the S mark on the i bobbin case aligns with the z mark on the machine. a 2 Grasp both sides of the needle plate cover, and then slide it toward you. b a b a 1 Needle plate cover ■ If there is no screw in the needle plate cover 1 Grasp both sides of the needle plate cover, and then slide it toward you. • Align the S and z marks. A a 1 Needle plate cover Remove the bobbin case. g Grasp the bobbin case, and then pull it out. 1 S mark 2 z mark 3 Bobbin case • Make sure that the indicated points are aligned before installing the bobbin case. Insert the tabs on the needle plate cover into the j needle plate, and then slide the cover back on. MAINTENANCE AND TROUBLESHOOTING 1 1 Bobbin case Use the cleaning brush or a vacuum cleaner to remove h any lint and dust from the race and the surrounding area. 1 Cleaning brush 2 Race • Do not apply oil to the bobbin case. a 1 Needle plate cover CAUTION • Never use a bobbin case that is scratched, otherwise the upper thread may become tangled, the needle may break or sewing performance may suffer. For a new bobbin case, contact your nearest Brother authorized service center. • Be sure that the bobbin case is correctly installed, otherwise the needle may break. Appendix A-3