Brother International Innov-is NQ3700D Operation Manual - Page 17

LCD Operation Settings screen Press to change the default machine settings. Press or , after you changed necessary settings. Memo • The latest version of software is installed in your machine. Check with your local authorized Brother dealer or at " http://s.brother/cpham/ " for available updates. • You can save the current settings screen image in a USB flash drive by pressing when the USB flash drive is inserted into the USB port. The files are saved in a folder labeled "bPocket". ■ Sewing settings 1 2 3 4 5 6 7 8 9 0 A B C 1 Select whether to use the sewing speed controller to determine the zigzag width. (page 66) 2 Make adjustments to character or decorative stitch patterns. (page 73) 3 Set to [ON] when using twin needle. (page 71) 4 Adjust the height of the presser foot when the presser foot is raised. 5 Adjust the presser foot pressure. The higher the number, the greater the pressure will be. Set the pressure at [3] for normal sewing. 6 Select either "1-01 Straight stitch (Left)" or "1-03 Straight stitch (Middle)" as the utility stitch that is automatically selected when the machine is turned on. 7 Adjust the height of the presser foot when sewing is stopped when the pivot key is selected. (page 37) 8 Adjust the height of the presser foot when the machine is set to free motion sewing mode. (page 64) 9 When set to [ON], the thickness of the fabric is automatically detected by an internal sensor while sewing. This enables the fabric to be fed smoothly. (page 36) 0 When set to [ON], reinforcement stitches are sewn at the beginning and/or end of sewing for a reinforcement stitch pattern, even when the (Reverse stitch button) is pressed. A When set to [ON], pressing the "Start/Stop" button (or depressing the foot controller) automatically lowers the presser foot when it is raised, allowing sewing to begin. B When set to [ON], pressing the "Start/Stop" button (or releasing the pedal of the foot controller) to stop sewing, it will then automatically raise the presser foot. The presser foot is raised to the height specified for [Presser Foot Height] on page 2 of the settings screen. When the pivot setting is selected, the presser foot is raised to the height specified for [Pivoting Height] on page 3 of the settings screen. C When set to [ON], pressing (Thread cutter button) automatically lowers the presser foot when it is raised, allowing the thread to be cut. After the thread is cut, the presser foot is raised again. ■ Embroidery settings GETTING READY 1 1 2 3 4 5 6 7 8 9 0 A B C 1 Select the embroidery frame to be used. 2 Select the center mark and grid lines that are displayed. 3 When set to [ON], you can only select the embroidery pattern corresponding to the embroidery frame size that you selected in 1. (page 86) 4 Change the thread color display on the embroidery screen; thread number, color name. (page 89) 5 When the thread number [#123] is selected, select from thread brands. (page 89) 6 Select the maximum embroidery speed setting. 7 Adjust the upper thread tension for embroidering. (page 91) 8 When set to [ON], pressing the "Start/Stop" button when the presser foot is raised automatically lowers the presser foot before starting embroidering. (page 91) 9 Select the height of the embroidery foot during embroidering. (page 82) 0 Select the color of the background for the embroidery display area. A Select the color of the background for the thumbnail area. B Select the size of pattern thumbnails. C Select the display units (mm/inch). 15