Brother International Innov-is NQ3700D Operation Manual - Page 60
Button sewing
![]() |
View all Brother International Innov-is NQ3700D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Utility Stitches ■ Sewing buttonholes on stretch fabrics When sewing buttonholes on stretch fabrics, use a gimp thread. Hook the gimp thread onto the part of buttonhole foot a "A" shown in the illustration. Button sewing Buttons can be sewn on with the machine. Buttons with two or with four holes can be attached. Measure the distance between the holes in the button a to be attached. It fits into the grooves, and then loosely tie it. b Attach buttonhole foot "A". c Select a stitch. d No. Stitch 4-05 4-06 • For details, refer to "Stitch Chart" on page 45. Adjust the stitch width to the thickness of the gimp e thread. Lower the presser foot lever and the buttonhole lever, f and then start sewing. When sewing is finished, gently pull the gimp thread to g remove any slack. Use a handsewing needle to pull the gimp thread to the h wrong side of the fabric, and then tie it. Remove the flat bed attachment. b Raise the presser foot lever, and then slide the feed dog c position switch, located at the rear of the machine on the base, to (to the left as seen from the rear of the machine). Attach button fitting foot "M". d Select a stitch. e No. 4-14 Stitch • For details, refer to "Stitch Chart" on page 45. • Since the end of the thread will be tied off later, do not set the machine for automatic thread cutting. Adjust the stitch width so that it is the same as the f distance between the holes in the button. Place the button in the position where it will be sewn, g and lower the presser foot lever. 1 Button a • When attaching four-hole buttons, first sew the two holes closest to you. Then, slide the button so that the needle goes into the two holes toward the rear of the machine, and then sew them in the same way. 58
![](/manual_guide/products/brother-international-innovis-nq3700d-operation-manual-bd00ebd/60.png)