Canon FAXPHONE L170 FAXPHONE L180 Basic Guide - Page 105

Specifying the Paper Size and Type (Common for Cassette and Multi-Purpose Feeder) NOTE • When making copies on LTR-size paper after having continuously copied on paper smaller than LTR-size paper, the copies may be dirty. To prevent copies from being dirty, wait about 1 minute before making copies. • The paper in the multi-purpose feeder is fed prior to the paper in the cassette. • The settings changed in the Menu do not return automatically to the settings you set previously. Change to the previous settings again if necessary. • When making copies of a small size or heavy paper*, etc., the copy speed may be slightly slower than usual. * The paper type should be selected in the Menu. • If you intend to make a copy and print with a thermal transfer printer using the same sheet of paper, make the copy first. Failure to do so may make copies dirty or cause a paper jam. • When copying onto transparencies, remove each transparency from the output tray as it is output. Specifying the Paper Size At the factory, the paper size has already been set to . Normally, you can make copies in this setting. When making copies on other sizes of paper, you need to specify the paper size according to the following. Making Copies 10 1 Press [Menu]. 2 Press [ (-)] or [ (+)] to select ➞ press [Set]. 3 Press [ (-)] or [ (+)] to select or ➞ press [Set]. 4 Press [ (-)] or [ (+)] to select ➞ press [Set]. 5 Press [ (-)] or [ (+)] to select the appropriate paper size (LTR, LGL, EXECUTIV, A4, B5, A5, ENVELOPE, or FREESIZE) ➞ press [Set]. ● When is selected: ❑ Press [ (-)] or [ (+)] to select the appropriate envelope type (DL, ISO-C5, COM10, or MONARCH) ➞ press [Set]. ● When is selected: ❑ Press [ (-)] or [ (+)] to select or ➞ press [Set]. ❑ Use the numeric buttons, or press [ (-)] or [ (+)] to specify vertical and horizontal sizes of the paper in millimeters (mm). Available setting range in : 127 mm to 356 mm (5" to 14") Available setting range in : 76 mm to 216 mm (3" to 8 1/2") ❑ Press [Set]. Repeat the steps above to specify both vertical and horizontal sizes of the paper. 6 Press [Stop/Reset] to return to standby mode. 10-2 Specifying the Paper Size and Type (Common for Cassette and Multi-Purpose Feeder)