Canon imagePROGRAF PRO-1000 series User Manual - Page 538

• Other Paper If the paper corners curl more than 0.1 inch / 3 mm (A) in height, the paper may smudge or may not feed properly. Follow the instructions below to correct the paper curl. 1. Roll up paper in opposite direction to paper curl as shown below. 2. Check that paper is now flat. We recommend printing curl-corrected paper one sheet at a time. Note • Depending on paper type, the paper may smudge or may not feed properly even if it is not curled inward. Follow the instructions below to curl the paper outward up to 0.1 inch / 3 mm (B) in height before printing. This may improve the print result. (C) Print side We recommend feeding paper that has been curled outward one sheet at a time. Check4 Set printer to prevent paper abrasion. Adjusting the setting to prevent paper abrasion will widen the clearance between the print head and the paper. If you notice abrasion even with the media type set correctly to match the paper, set the printer to prevent paper abrasion using the operation panel. * Once you have finished printing, undo this setting. Otherwise, it will apply to subsequent print jobs. Press the HOME button, select Various settings, Device settings, and Print settings, and then set Prevent paper abrasion to ON. Changing Settings from Operation Panel Check5 Specify a paper size that has 25 mm margins. If the top or bottom edge of the printing surface has been scratched or smudged, print with a paper size that has wide margins (25 mm margins). When you print on Photo Paper Pro Premium Matte PM-101 or Matte Photo Paper MP-101, we recommend that you print with a 25 mm margins paper size or 4" x 6" (10 x 15 cm) size. 538