Canon imagePROGRAF iPF770 MFP M40 Basics Guide - Page 128
Top cover is open., Prepare for parts replacement., Parts replacement time has passed., Unknown file.
View all Canon imagePROGRAF iPF770 MFP M40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Top cover is open. iPF770 Series Hardware error. 03130031-2F7x (x is 0, 1, or 2) Cause The ink tank is not installed correctly. Corrective Action Turn off the power, remove and then reinstall all of the ink tanks, and then turn on the power. If the same message is displayed again, write down the error code and message, turn off the printer, and contact your Canon dealer for assistance. (See "Replacing Ink Tanks.") ➔P.24 Top cover is open. Cause The printer has detected that the Top Cover is open. Corrective Action Open the Top Cover fully, remove any foreign objects, and close the Top Cover again. If the error occurs again, close the Top Cover, turn off the printer, and wait a while before restoring power. Prepare for parts replacement. Cause It is almost time to replace consumables for which service is required. Corrective Action If "Parts replacement time has passed." is displayed, you can continue to use the printer for some time. Contact your Canon dealer for assistance. Parts replacement time has passed. Cause Corrective Action It is past the recommended time to replace consumables for which service is required. Contact your Canon dealer for assistance. Unknown file. Cause Data sent to keep the printer up to date (such as paper information) is in the wrong format. You have uploaded firmware for a different model. Corrective Action Check the data. Turn off the printer and wait a while before restoring power, and then resend the data. Check the firmware version. Turn off the printer and wait a while before restoring power, and then resend the firmware. If the message is displayed again, contact your Canon dealer for assistance. Multi-sensor error Cause Direct sunlight or strong lighting may be shining on the printer and causing the sensor to malfunction. The performance of a sensor inside the printer may be impaired. Corrective Action Take steps to ensure the printer is not used when exposed to direct sunlight or strong lighting. Turn off the printer and wait at least three seconds before restoring the power. If the message is displayed again, contact your Canon dealer for assistance. Error in cutter position. Cause The Cutter Unit stops in the middle of cutting. Corrective Action 1. Push the Release Lever back and remove the paper. 2. Pull the Release Lever forward. Error Message Other Messages 128 Basic Guide