Canon imagePROGRAF iPF850 User Guide - Page 382

Handling and Use of Paper Ejecting to the Output Stacker 4 Lift up the Ejection Guide (b) until the Ejection Support (a) tip is at a higher position than the Output Stacker tip, and then lower it again. b The Ejection Support is moved in front of the Output Stacker tip. This completes the preparation for ejecting to the output stacker. Start printing. iPF850 a • When lifting up the Ejection Guide, lift it up slowly. If you lift it up too vigorously, the Ejection Guide may Important strike the Top Cover, damaging the printer. • Do not leave printed documents in the stacker for a long period of time. This may cause uneven colors of the printed documents, etc. • Close the Output Stacker when you are not using the Output Stacker. If you install it on the Stacker while the Output Stacker is open, the Output Stacker will touch the printer and may cause damage. • Depending on the type of paper, the edge may curl or bend during ejection. In this case, straighten out the paper. If the paper is curled or bent, it may damage printed documents. • Store the Output Stacker when printing long documents such as banners. It is recommended that you spread a clean cloth or paper on the floor and select Eject as the method for cutting roll paper to prevent that printing from becoming soiled or scratched. (See "Specifying the Cutting Method for Rolls.") ➔P.360 Stacker 382 User's Guide