Cisco AS5400XM Installation Guide - Page 44
Verification, Getting Help, Where to Go Next, show running-config, line-termination 75-ohm
UPC - 746320997261
View all Cisco AS5400XM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Getting Help Chapter 3 T1 and E1 Feature Cards Verification To verify the impedance, enter the show running-config command. Note By default, input impedance is 120 ohm. In the following example, the input impedance was successfully changed to 75 ohm using the line-termination 75-ohm command. Some of the configuration has been deleted for readability. Router# show running-config Building configuration... Current configuration: . . . ! controller E1 0 clock source free-running line-termination 75-ohm pri-group timeslots 1-31 ! . . . Router# Getting Help For information about technical support, onsite service, and exchange and repair services, see the "Obtaining Technical Assistance" section on page xvi. Where to Go Next The remaining chapters of this guide include information about installing and troubleshooting feature cards and about building cables. • Chapter 4, "Channelized T3 Feature Card" • Chapter 5, "Universal Port and Dial-Only Feature Cards" • Chapter 6, "Voice Feature Card" • Chapter 7, "Troubleshooting" • Appendix A, "Cabling Specifications" 3-12 Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide 78-17406-01