Cisco DS-C9124-K9 Troubleshooting Guide - Page 471
Host Login Problems, ITL Problems, Common Mismatch Problems, Problem, Description
View all Cisco DS-C9124-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 471 highlights
Chapter 23 Troubleshooting SANTap SANTap Issues Send documentation comments to [email protected] Host Login Problems Host login problems can be caused by DVT limitations, connectivity, or other issues. To diagnose host login problems, follow these steps: Step 1 Step 2 Step 3 Step 4 Step 5 Use the show santap vttbl dvt dvt-pwwn command to display SANTap information for the DVT. Use the show santap vttbl dvt dvt-pwwn host-pwwn command to display SANTap information for the DVT and the host. Enable logging on the appropriate SSM module. Issue the following debug commands: a. debug vsd vfc-felogin b. debug partner 0x92810000 d1 c. debug partner 0x92810000 d2 Review the logs to determine the problem and then take the appropriate corrective action. ITL Problems An ITL problem may occur if the number of ITLs exceeds the limitations for the version of Cisco SAN-OS and SSI in use. For specific ITL limitations, see the "Limitations" section on page 23-2 To diagnose and resolve ITL problems, follow these steps: Step 1 Step 2 Step 3 Use the show isapi dpp 4 queue command to display DPP queue information. Verify that the number of ITLs on a DPP is within the limitations for the version of Cisco SAN-OS and SSI in use. Use the show isapi dpp 4 queue incl LUN and show isapi dpp 4 queue count commands. Verify that the number of ITLs on an SSM is within the limitations for the version of Cisco SAN-OS and SSI in use. Issue the show isapi dpp all queue command, using the incl LUN and count parameters. Common Mismatch Problems Problems are often caused by mismatching component versions, or using devices that are not supported by the interoperability matrix. The following lists common mismatch situations: Table 23-3 Common SANTap Mismatch Problems Problem Description Version mismatch between SSM and the RPA. The version of SSM and the version of the replication appliance are not compatible. Version mismatch between the Supervisor and the The version of the Sup and the SSI image are not SSI image. compatible. OL-9285-05 Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x 23-7