Cisco VG224 Hardware Installation Guide - Page 57
Powering On the Cisco VG224 Voice Gateway, Checklist for Power-On, Power-On Procedure
UPC - 746320575360
View all Cisco VG224 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
CH A P T E R 4 Powering On the Cisco VG224 Voice Gateway To power on your Cisco VG224 voice gateway, perform the following tasks in the order listed, as required: • Checklist for Power-On, page 4-1 • Power-On Procedure, page 4-1 • Initial Configuration Procedures, page 4-2 • Troubleshooting, page 4-4 Checklist for Power-On You can power on a Cisco VG224 voice gateway if it meets the requirements described in Chapter 3, "Installing the Cisco VG224 Voice Gateway": • The chassis is securely mounted. • Power cable is connected. • Interface cables are connected. Power-On Procedure Perform this procedure to power on your Cisco VG224 voice gateway and verify that it goes through its initialization and self-test. When this is finished, the Cisco VG224 voice gateway is ready to configure. To power on the Cisco VG224 voice gateway, follow this procedure: Step 1 Step 2 Power on your terminal or PC, and configure it for 9600 bps, 8 data bits, 1 stop bit, and no parity. Move the Cisco VG224 voice gateway power switch to the ON position. The green LED next to the auxiliary port should come on and the fan should operate. If this does not happen, see the "Troubleshooting" section on page 4-4. The following message is displayed at the end of the boot-up messages: --- System Configuration Dialog --Would you like to enter the initial configuration dialog? [yes/no]: OL-5006-04 Cisco VG224 Voice Gateway Hardware Installation Guide 4-1