Compaq DL580 Service Guide - Page 77
Table 3-2, POST Error Messages, Error Code, Audible Beeps, Probable Source of Problem
UPC - 720591733483
View all Compaq DL580 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
3-8 Compaq ProLiant DL580 Server Maintenance and Service Guide Table 3-2 POST Error Messages Error Code A Critical Error occurred prior to this power up Unsupported Processor Detected System Halted Audible Beeps None 1 long, 1 short FATAL ROM ERROR: The System ROM is not properly programmed 101-ROM Error 1 long, 1 short 1 long, 1 short 101-I/O ROM Error None 102-System Board Failure 104-ASR-2 Timer Failure 105-Current System ROM is corrupt - now booting redundant System ROM 162-System Options Not Set 163-Time & Date Not Set 164-Memory Size Error 172-Configuration Nonvolatile Memory Invalid 173-Slot ID Mismatch 174-Configuration/ Slot Mismatch Device Not Found 175-Configuration/ Slot Mismatch Device Found None None 2 long 2 short 2 short 2 short None None None None Probable Source of Problem A catastrophic system error, which caused the server to crash, has been logged. Processor not supported by current system ROM ROM incorrectly programmed in factory Recommended Action Run Diagnostics. Replace failed assembly as indicated. Check documentation for supported processors, and if supported, remove the processor and update the system to latest ROM. Replace the physical ROM part. System ROM checksum Options ROM checksum DMA, timers System board failure Nonbooted ROM image is corrupt Run Diagnostics, then replace failed assembly as indicated. Run Diagnostics, then replace failed assembly as indicated. Replace the system board. Run the System Configuration Utility. Run Diagnostics. Replace failed assembly as indicated. Flash the ROM utilizing ROMPaq. Configuration incorrect Invalid time or date in configuration memory Configuration memory incorrect Nonvolatile configuration corrupt or jumper installed Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Board replaced, configuration not updated EISA or PCI board not found Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. EISA or PCI board added, configuration not updated Run the System Configuration Utility and correct. continued