Compaq DL580 Service Guide - Page 78

Diagnostics and Troubleshooting 3-9 Table 3-2 POST Error Messages continued Error Code Audible Beeps 177-Configuration None Not Complete 178-Processor None Configuration Invalid 180-Log Reinitialized None 201-Memory Error None 203-Memory Address Error 207-Invalid Memory Configuration - Check DIMM [SIMM] Installation 208-Invalid Memory Speed - Check DIMM [SIMM] Installation None None 1 long, 1 short 209-Memory Detection Failure. Check Memory Installation 211-Cache Switch Set Incorrectly 212-System Processor Failed/ Mapped out 218-Cache Accelerators Not Installed. System Halted. 219-Tag Update Rules SRAM Failure. System Halted 1 long, 1 short None 1 short None None Probable Source of Problem Incomplete system configuration Processor type or step does not match configuration memory. N/A RAM failure RAM failure Memory module installed incorrectly Recommended Action Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. N/A Run Diagnostics, then replace failed assembly as indicated. Run Diagnostics, then replace failed assembly as indicated. Verify placement of memory modules. The speed of the memory is too slow: xx00 = expansion board SIMMs are too slow 00yy = system board SIMMs are too slow xx and yy have a corresponding bit set Unable to size memory The speed of the memory modules must be 60 ns. Verify the speed of the memory modules installed, and replace if slower than 60 ns. Check DIMM installation and if error persists, call Compaq authorized service provider. Switch not set properly during installation or upgrade Processor in slot X failed Verify switch settings. Run Diagnostics, then replace failed processor. Cache accelerators not installed or improperly installed Check cache accelerator installation. Catastrophic chipset failure Call Compaq authorized service provider. continued