Compaq DL580 Service Guide - Page 79

3-10 Compaq ProLiant DL580 Server Maintenance and Service Guide Table 3-2 POST Error Messages continued Error Code Audible Beeps 219-Snoop Rules None SRAM Failure. System Halted. 220-Cache None Accelerator Slot x Initialization Failed. System Halted. 301-Keyboard Error None 301-Keyboard Error None or Test Fixture Installed * ZZ-301-Keyboard None Error 303-Keyboard None Controller Error 304-Keyboard or None System Unit Error 40X-Parallel Port X Address Assignment Conflict 601-Diskette Controller Error 2 short None 605-Diskette Drive Type Error 2 short 1151-Com Port 1 Address Assignment Conflict 2 short * ZZ represents the Keyboard Scan Code. Probable Source of Problem Catastrophic chipset failure Cache accelerator in slot x improperly installed or bad Keyboard failure Keyboard failure Recommended Action Call Compaq authorized service provider. Check cache accelerator installation and if properly installed, replace. Power down the computer, then reconnect the keyboard. Replace the keyboard. Keyboard failure System board, keyboard, or mouse controller failure Keyboard, keyboard cable, or system board failure Both external and internal ports are assigned to parallel port X. 1. A key is stuck. Try to free it. 2. Replace the keyboard. Run Diagnostics, then replace failed assembly as indicated. 1. Make sure the keyboard is attached. 2. Run Diagnostics to determine whether the keyboard, keyboard cable, or system board is in error. 3. Replace the part indicated. Run the System Configuration Utility and correct. Diskette controller circuitry failure Mismatch in drive type Both external and internal serial ports are assigned to COM1. 1. Make sure the diskette drive cables are attached. 2. Replace the diskette drive and/or cable. 3. Replace the system board. Run the System Configuration Utility to set diskette type correctly. Run the System Configuration Utility and correct. continued