D-Link DES-3350SR Reference Manual - Page 198

DES-3350SR Layer 3 Fast Ethernet Switch User's Guide Each command is listed, in detail, in the following sections. create route redistribute dst ospf Purpose Used to add route redistribution settings for the exchange of RIP routes to OSPF routes on the switch. Syntax create route redistribute dst ospf src [static|rip|local] {mettype [1|2]|metric } Description This command will redistribute routing information between the OSPF and RIP routing protocols to all routers on the network that are running OSPF or RIP. Routing information entered into the Static Routing Table on the local DES-3350SR switch is also redistributed. Parameters src [static|rip|local] − Allows for the selection of the protocol for the source device. dst − Allows for the selection of the protocol for the destination device. mettype [1|2] − Allows for the selection of one of two methods of calculating the metric value. Type-1 calculates (for RIP to OSPF) by adding the destination's interface cost to the metric entered in the Metric field. Type-2 uses the metric entered in the Metric field without change. This field applies only when the destination field is OSPF. 198