Home » D-Link Manuals » Hubs & Switches » D-Link DES-3350SR » Manual Viewer

D-Link DES-3350SR Reference Manual - Page 40

enable telnet, local>disable clipaging, Command: disable clipaging, Success., local&gt

UPC - 790069254499

Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

DES-3350SR Layer 3 Fast Ethernet Switch User's Guide local>disable clipaging Command: disable clipaging Success. local> enable telnet Purpose Used to enable communication with and management of the switch using the Telnet protocol. Syntax enable telnet Description This command is used to enable the Telnet protocol on the switch. The user can specify the TCP or UDP port number the switch will use to listen for Telnet requests. Parameters − The TCP port number. TCP ports are numbered between 1 and 65535. The "well-known" TCP port for the Telnet protocol is 23. Restrictions Only administrator-level users can issue this command. Example Usage: To enable Telnet and configure port number: local>enable telnet 23 40

Section	Page
Introduction	11
	11
	11
Accessing the Switch via the Serial Port	11
Setting the Switch’s IP Address	12
Using the Console CLI	16
	16
	16
Connecting to the Switch	16
Command Syntax	24
Basic Switch Commands	28
Switch Port Commands	48
Network Management Commands	52
Download/Upload Commands	88
Network Monitoring Commands	92
Spanning Tree Commands	100
Forwarding Database Commands	111
Broadcast Storm Control Commands	123
QOS Commands	127
Port Mirroring Commands	146
VLAN Commands	152
Link Aggregation Commands	166
IP Interface Commands	176
ARP Commands	184
Routing Table Commands	192
Route Redistribution Commands	197
IGMP Commands	209
IGMP Snooping Commands	214
802.1X Commands	229
Access Control List (ACL) Commands	252
BOOTP Relay Commands	268
DNS Relay Commands	275
RIP Commands	285
DVMRP Commands	294
PIM Commands	303
IP Multicasting Commands	310
MD5 Configuration Commands	314
OSPF Configuration Commands	319
SNTP Commands	355
Command History List	360
Technical Specifications	366