Home » D-Link Manuals » Hubs & Switches » D-Link DES-3350SR » Manual Viewer

D-Link DES-3350SR Reference Manual - Page 290

config rip all, enable rip, local>config rip all state enabled, Success., local&gt

UPC - 790069254499

Add to My Manuals
Save this manual to your list of manuals

Page 290 highlights

DES-3350SR Layer 3 Fast Ethernet Switch User's Guide config rip all this command. Example Usage: To change the RIP state to enabled for all the IP interfaces on the switch: local>config rip all state enabled Command: config rip all state enabled Success. local> enable rip Purpose Syntax Description Parameters Restrictions Used to enable RIP. enable rip This command is used, along with the disable RIP command below, to enable or disable RIP on the switch. none. Only administrator-level users can issue this command. Example Usage: 290

Section	Page
Introduction	11
	11
	11
Accessing the Switch via the Serial Port	11
Setting the Switch’s IP Address	12
Using the Console CLI	16
	16
	16
Connecting to the Switch	16
Command Syntax	24
Basic Switch Commands	28
Switch Port Commands	48
Network Management Commands	52
Download/Upload Commands	88
Network Monitoring Commands	92
Spanning Tree Commands	100
Forwarding Database Commands	111
Broadcast Storm Control Commands	123
QOS Commands	127
Port Mirroring Commands	146
VLAN Commands	152
Link Aggregation Commands	166
IP Interface Commands	176
ARP Commands	184
Routing Table Commands	192
Route Redistribution Commands	197
IGMP Commands	209
IGMP Snooping Commands	214
802.1X Commands	229
Access Control List (ACL) Commands	252
BOOTP Relay Commands	268
DNS Relay Commands	275
RIP Commands	285
DVMRP Commands	294
PIM Commands	303
IP Multicasting Commands	310
MD5 Configuration Commands	314
OSPF Configuration Commands	319
SNTP Commands	355
Command History List	360
Technical Specifications	366