D-Link DGS-3630-52PC Web UI Reference Guide 2 - Page 259

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide The fields that can be configured in RIPng Global Settings are described below: Parameter Global State Description Select to globally enable or disable the RIPng feature here. Click the Apply button to accept the changes made. The fields that can be configured in RIPng Settings are described below: Parameter Default Metric Distance Update Time Invalid Time Flush Time Poison Reverse Split Horizon Description Enter the default metric value here. The range is from 1 to 16. This value is used to specify the default metric for routes redistributed from other routing protocols. If the routes being redistributed are learned from other protocols, then they have an incompatible metric with IPv6 RIP. Re-specifying of metric allows the metric to be synced. Select the Default option to use the default metric value, which is 1. Enter the administrative distance for RIPng here. The range is from 1 to 254. The distance value represents the trust rating of the route. The route with a lower distance value is preferred over the route with the higher distance value. A route with a distance of 255 will not be installed for the routing of packets since it indicates that the route is not trusted. Select the Default option to use the default administrative distance for RIPng, which is 120. Enter the update interval value at which the update message is sent here. The range is from 5 to 65535 seconds. Select the Default option to use the default value here which is 30 seconds. Enter the invalidate timer value in seconds here. The range is from 1 to 65535 seconds. Select the Default option to use the default value here which is 180 seconds. Enter the flush timer value in seconds here. The range is from 1 to 65535 seconds. Select the Default option to use the default value here which is 120 seconds. Select to enable or disable the Poison Reverse feature here. When Poison Reverse is enabled, the routes learned from an interface will be advertised out to the same interface with an unreachable metric. Select to enable or disable the Split Horizon feature here. When Split Horizon is enabled, the routes learned from an interface will be not advertised out to the same interface. Click the Apply button to accept the changes made. The fields that can be configured in Redistribute Settings are described below: Parameter Protocol Metric Description Select the protocol whose routes are to be redistributed here. Options to choose from are Connected, Static, OSPF, BGP, and ISIS. The Static option means to redistribute IPv6 static routes. The Connected option refers to routes that are established automatically by virtue of configuring IPv6 address on an interface. Enter the value to be used as the metric for the redistributed routes here. The range is from 0 to 16. Select the Default option to use the default metric value. Click the Apply button to accept the changes made. Click the Delete button to delete an entry based on the information entered. 247