D-Link DGS-3630-52PC Web UI Reference Guide 2 - Page 594

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide Parameter MAC Limit Description to remote peers in this VPLS here. The MTU value must be same at both the local and remote sites to establish the PW. If the MTU is specified as 0, then local the MTU will not be advertised to remote peers in the VPLS. The range is from 0 to 65535 bytes. By default, this value is 1500 bytes. Select and enter the MAC limit value here. This is used to configure the MAC address learning entry number limitation in the VPLS. After a non-zero MAC address learning limitation was configure here, and when the number of MAC addresses learned exceeds this limit, the packets with unlearned source MAC addresses in the VPLS will be dropped. The range is from 0 to 1000000. Click the Apply button to accept the changes made. The fields that can be configured for Neighbor Settings are described below: Parameter Remote Peer VC ID Type No-Split-Horizon Description Enter the LSR ID that is used to identify the PE to which the peer belongs to here. Enter the PW VC ID here. The range is from 1 to 4294967295. It is used with the IP address to uniquely identify a peer for a VPLS. If not specified, the PW ID is set by the VPN ID of this VPLS. Select the type here. Options to choose from are Backup and Standalone. Selecting the Backup option will create a backup peer for PW redundancy of an H-VPLS. Selecting this option specifies that a peer is used as the spoke PW. The packets from other PWs in the VPLS can be forwarded to this PW and the packets from this PW can be forwarded to other PWs in the VPLS. If this option is not specified, the peer is used as a network PW. The packets from other network PWs in a VPLS must not be forwarded to this PW and the packets from this PW must not be forwarded to other network PWs in the VPLS. Click the Apply button to accept the changes made. The fields that can be configured for Dot1q Tunneling Ethertype Settings are described below: Parameter Dot1q Tunneling Ethertype Description Enter the outer TPID for the service VLAN tag here. This value is in the hexadecimal form and the range is from 0x1 to 0xFFFF. Click the Apply button to accept the changes made. The fields that can be configured for VLAN Mode Settings are described below: Parameter VLAN Mode Description Select the VLAN mode of the VPLS here. The VLAN mode will affect the VLAN handling of the encapsulated packet for all PWs that belong to this VPLS. Options to choose from are: • No Change - Specifies not to change the VLAN tag on the ingress packet. This can only be applied on Ethernet VLAN-based ACs. • Add VLAN - Specifies to add the configured VLAN tag to the ingress packet. The default action for port-based ACs is to add the VLAN ID of 0. This can be applied on both Ethernet-based and Ethernet VLAN-based ACs. • Change VLAN - Specifies to change the VLAN tag of the ingress packet to the configured VLAN ID. This can only be applied on Ethernet VLAN-based ACs. Select the None option to use the default setting. Click the Apply button to accept the changes made. 582