D-Link DGS-3630-52PC Web UI Reference Guide 2 - Page 578

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide Figure 11-8 MPLS LDP Interface Settings Window The fields that can be configured are described below: Parameter Interface VID LDP State Discovery Accept Distribution Mode Description Enter the interface VLAN ID used here. The range is from 1 to 4094. Select to enable or disable the LDP feature on the specified interface here. Select to enable or disable the discovery accept feature here. If targeted hello message acceptance is disabled in the interface, and if the received targeted hello is not coming from the local configured targeted peer, the message will be ignored. If targeted hello message acceptance is enabled in the interface, LSR will honor the received targeted hello messages sent by all neighbors. Select the distribution mode here. Options to choose from are: • DU - Specifies the downstream unsolicited distribution mode. • DoD - Specifies the downstream on-demand distribution mode. Discovery Hello Interval Discovery Hello Hold Time Enter the discovery hello interval value here. The range is from 1 to 65535 seconds. Select the Default option to use the default value. Enter the discovery hello hold-time value here. The range is from 5 to 65535 seconds. Select the Default option to use the default value. Click the Apply button to accept the changes made. Click the Find button to locate a specific entry based on the information entered. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. MPLS LDP Session Information This window is used to find and display the MPLS LDP session information. To view the following window, click MPLS > MPLS LDP Session Information, as shown below: 566