Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 100

www.dell.com | support.dell.com reset c e Reset a line card, RPM, a standby SFM (EtherScale only), or a failed SFM (TeraScale only). Syntax reset {linecard number [hard | power-cycle] | rpm number [hard | power-cycle ] | sfm slot number | standby} Parameters linecard number hard power-cycle rpm number sfm standby sfm slot number Enter the keyword linecard and a number for the line card slot number. (Optional) Add the keyword hard or power-cycle (power-cycle is C-Series only) to power cycle the line card. C-Series Range: 0-7 E-Series Range: 0 to 13 on E1200/E1200i, 0 to 6 on E600/E600i, and 0 to 5 on E300 Enter the keyword hard to power cycle the line card. Enter the keyword power-cycle after upgrading a C-Series FPGA to cause the FPGA to be reprogrammed based on the contents of the FPGA PROM. Note: This option is supported on C-Series only. Enter the keyword rpm followed by a number for the RPM slot number. (Optional) Add the keyword hard or power-cycle (C-Series only) to power cycle the RPM. Range: 0 to 1 Enter the keyword sfm standby to reset the standby SFM. Note: This option is supported on E-Series EtherScale only. Enter the keyword sfm followed by the failed or powered-off SFM slot number. Note: Supported on E-Series only Defaults Disabled. Command Modes EXEC Privilege Command History Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage Information The command reset without any options is a soft reset, which means FTOS boots the line card from its runtime image. The hard option reloads the FTOS image on the line card. Use the power-cycle after upgrading an FPGA. When a soft reset is issued on a line card (reset linecard number), FTOS boots the line card from its runtime image. Only when you enter reset linecard number hard is the software image reloaded on the line card. Related Commands reload restore fpga-image Reboots the system. Copy the backup C-Series FPGA image to the primary FPGA image. rpm location-led ex Toggle the location LED on/off on the E-Series ExaScale RPM (LC-EH-RPM). Syntax rpm slot number location-led [on | off] 100 | Control and Monitoring