Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 666

www.dell.com | support.dell.com Related Commands clear ip fib linecard Clear FIB entries on a specified line card. show ip fib stack-unit s View all Forwarding Information Base (FIB) entries. Syntax show ip fib stack-unit 0-7 [ip-address [mask] [longer-prefixes] | summary] Parameters 0-7 ip-address mask longer-prefixes summary Enter the S-Series stack unit ID, from 0 to 7. (OPTIONAL) Enter the IP address of the network destination to view only information on that destination. Enter the IP address in dotted decimal format (A.B.C.D). You must enter the mask in slash prefix format (/X). (OPTIONAL) Enter the keyword longer-prefixes to view all routes with a common prefix. (OPTIONAL) Enter the keyword summary to view the total number of prefixes in the FIB. Command Mode Command History EXEC EXEC Privilege Version 7.7.1.0 Version 7.6.1.0 Modified: Added support for up to seven stack members. Introduced on S-Series Example Figure 24-14. show ip fib linecard Command Example FTOS#show ip fib stack-unit 0 Destination Gateway First-Hop Mac-Addr Port VId EC 10.10.10.10/32 Direct, Nu 0 0.0.0.0 00:00:00:00:00:00 BLK HOLE 0 0 FTOS> Table 24-11. show ip fib linecard Command Example Fields Field Destination Gateway First-Hop Mac-Addr Port VId EC Description Lists the destination IP address. Displays either the word Direct and an interface for a directly connected route or the remote IP address to be used to forward the traffic. Displays the first hop IP address. Displays the MAC address. Displays the egress-port information. Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed. Displays the number of ECMP paths. 666 | IPv4 Routing