Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 1518

www.dell.com | support.dell.com interface number Enter one of the following keywords and slot/port or number information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from 0 to 16383. • For the management interface on the RPM, enter the keyword ManagementEthernet followed by the slot/port information. The slot range is 0-1 and the port range is 0. • For the Null interface, enter the keywords null 0. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series Range: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Enter the linecard slot number. Range: 0-7 for the C300 Defaults None. Command Mode EXEC EXEC Privilege Command History Version 4.2.1.0 Introduction Usage Information Warning: Use this command only when you are working directly with a technical support representative to troubleshoot a problem. Do not use this command unless a technical support representative instructs you to do so. Layer 2 Debug Command show software macagent c This command displays tables and advanced debugging information related to the MAC Agent process. Syntax show software macagent {configs | mac-addr-table {dump | count} | port interface interface | port-channel number | stg number | vlan number} line-card number Parameters configs mac-addr-table dump count The keyword configs shows the initial configurations of the MAC Agent. The keyword mac-addr-table shows the number of MAC addresses in the MAC Agent software. The keyword dump shows the MAC addresses present in the software. The keyword count shows the number of MAC addresses present in the software. 1518 | C-Series Diagnostics and Debugging