Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 568

www.dell.com | support.dell.com duplex (Management) c e Set the mode of the Management interface. Syntax duplex {half | full} To return to the default setting, enter no duplex. Parameters half Enter the keyword half to set the Management interface to transmit only in one direction. full Enter the keyword full to set the Management interface to transmit in both directions. Defaults Not configured Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on E-Series ExaScale Introduced on C-Series Documentation modified-added Management to distinguish from duplex (10/100 Interfaces) Usage This command applies only to the Management interface on the RPMs. Information Related Commands interface ManagementEthernet duplex (Management) management route speed (Management interface) Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Configure a static route that points to the Management interface or a forwarding router. Set the speed on the Management interface. duplex (10/100 Interfaces) c e s Configure duplex mode on any physical interfaces where the speed is set to 10/100.Syntax duplex {half | full} To return to the default setting, enter no duplex. Parameters half Enter the keyword half to set the physical interface to transmit only in one direction. full Enter the keyword full to set the physical interface to transmit in both directions. Defaults Not configured Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced 568 | Interfaces