Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 1055

Parameters process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Command Modes EXEC EXEC Privilege Command History Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced support of Multi-Process OSPF. Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a Information specific OSPF process. If you do not enter the Process ID, only the first configured process is listed. Example Figure 38-17. Command Example: show ip ospf process-id neighbor FTOS#show ip ospf 34 neighbor Neighbor ID Pri State Dead Time Address 20.20.20.7 1 FULL/DR 00:00:32 182.10.10.3 192.10.10.2 1 FULL/DR 00:00:37 192.10.10.2 20.20.20.1 1 FULL/DROTHER00:00:36 192.10.10.4 FTOS# Interface Area Gi 0/0 0.0.0.2 Gi 0/1 0.0.0.1 Gi 0/1 0.0.0.1 Table 38-11. Command Example Descriptions: show ip ospf process-id neighbor Row Heading Neighbor ID Pri State Dead Time Address Interface Area Description Displays the neighbor router ID. Displays the priority assigned neighbor. Displays the OSPF state of the neighbor. Displays the expected time until FTOS declares the neighbor dead. Displays the IP address of the neighbor. Displays the interface type slot/port information. Displays the neighbor's area (process ID). show ip ospf routes c e s Display routes as calculated by OSPF and stored in OSPF RIB. Syntax show ip ospf process-id routes Parameters process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Defaults No default values or behavior Command Modes EXEC Open Shortest Path First (OSPFv2 and OSPFv3) | 1055