Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 1384

www.dell.com | support.dell.com • show interfaces • sonet-port-recover detection-interval • speed ais-shut e Enable an alarm indication signal (AIS) when the SONET interface is shutdown. Syntax ais-shut To disable the AIS, enter no ais-shut. Defaults Disabled. Command Modes INTERFACE alarm-report e Specify which POS/SDH alarms to report to the remote SNMP server. Syntax alarm-report {lais | lrdi | pais | plop | prdi | sd-ber | sf-ber | slof | slos} To disable an alarm, use the no alarm-report {lais | lrdi | pais | plop | prdi | sd-ber | sf-ber | slof | slos} command. Parameters lais lrdi pais plop prdi sd-ber sf-ber slof slos Enter the keyword lais to report line alarm indication signal. Enter the keyword lrdi to report line remote defect indicator. Enter the keyword pais to report path alarm indication signal. Enter the keyword plop to report path loss of pointer. Enter the keyword prdi to report the path remote defect indication. Enter the keyword sd-ber to report signal degradation BER errors. Enter the keyword sf-ber to report signal failure BER errors. Enter the keyword slof to report section loss of frame. Enter the keyword slos to report section loss of signal. Defaults Disabled-no alarm reporting for all alarms Command Modes INTERFACE Usage Information Alarm reporting is available with this command. SNMP traps are available; however, syslogs are not generated. To display active alarms and defects, use the show controllers command. The table below defines the alarms that can be enabled by this command. If enabled for reporting, the alarms will generate reports on a trap receiver. 1384 | SONET