Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 56

www.dell.com | support.dell.com Parameters sfm rpm all id Enter the keyword sfm to upgrade the FPGA on the SFMs. Enter the keyword rpm to upgrade all processors on the RPM. Enter the keyword all to upgrade the FPGA on all the SFMs. Enter the keyword id to upgrade the FPGA on all a specific SFM. Enter the path to the upgrade source. Entering updates the FPGA from the flash. Defaults No default values or behavior Command Modes EXEC Privilege Command History Version 8.3.1.0 Version 7.5.1.0 Added rpm option Introduced on E-Series Example Command example: upgrade sfm autoreset FTOS#upgrade sfm 1 autoreset SFM1: upgrade in progress SFM1: upgrade complete SFM1 is active. Resetting it might temporarily impact traffic. Proceed with reset [confirm yes/no]: yes FTOS# Related Commands show sfm upgrade (E-Series version) Display the SFM status. Upgrade the E-Series. 0Usage On E-Series ExaScale, you cannot upgrade SFMs using this command when Cache Boot is configured. Information If you attempt an upgrade, you must reload the chassis to recover. Upgrading the C-Series FPGA These commands are for upgrading the FPGA for C-Series RPMs and line cards. • restore fpga-imagee • upgrade fpga-image restore fpga-image c Copy the backup C-Series FPGA image to the primary FPGA image. Syntax restore fpga-image {rpm | linecard} number Parameters rpm linecard number Enter rpm to upgrade an RPM FPGA. Enter linecard to upgrade a line card FPGA. Enter the line card or RPM slot number. C-Series Line Card Range: 0-7, RPM Range: 0-1 56 | File Management