Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 740

www.dell.com | support.dell.com Related Commands bgp client-to-client reflection neighbor route-reflector-client show ip bgp ipv6 unicast cluster-list Enable route reflection between route reflector and clients. Configure a route reflector and clients. View paths with a cluster ID. bgp confederation identifier c e Configure an identifier for a BGP confederation. Syntax bgp confederation identifier as-number To delete a BGP confederation identifier, use the no bgp confederation identifier as-number command. Parameters as-number Enter the AS number. Range: 1 to 65535 Defaults Not configured. Command Modes Command History ROUTER BGP Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage Information The autonomous systems configured in this command are visible to the EBGP neighbors. Each autonomous system is fully meshed and contains a few connections to other autonomous systems. The next hop, MED, and local preference information is preserved throughout the confederation. FTOS accepts confederation EBGP peers without a LOCAL_PREF attribute. The software sends AS_CONFED_SET and accepts AS_CONFED_SET and AS_CONF_SEQ. bgp confederation peers c e Specify the Autonomous Systems (ASs) that belong to the BGP confederation. Syntax bgp confederation peers as-number [...as-number] To enter no bgp confederation peer. Parameters as-number ...as-number Enter the AS number. Range: 1 to 65535 (OPTIONAL) Enter up to 16 confederation numbers. Range: 1 to 65535. Defaults Not configured. 740 | IPv6 Border Gateway Protocol (IPv6 BGP)