Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 1101

Defaults Not configured. Command Modes CONFIGURATION Command History Version 7.8.1.0 Version 6.1.1.0 Introduced on S-Series Added support for VLAN interface ip pim dr-priority c e s Change the Designated Router (DR) priority for the interface. Syntax ip pim dr-priority priority-value To remove the DR priority value assigned, use the no ip pim dr-priority command. Parameters priority-value Enter a number. Preference is given to larger/higher number. Range: 0 to 4294967294 Default: 1 Defaults 1 Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.8.1.0 Introduced on E-Series ExaScale Introduced on C-Series on port-channels and S-Series Usage Information The router with the largest value assigned to an interface becomes the Designated Router. If two interfaces contain the same DR priority value, the interface with the largest interface IP address becomes the Designated Router. ip pim graceful-restart e This feature permits configuration of Non-stop Forwarding (NFS or graceful restart) capability of a PIM router to its neighbors. Syntax [ipv6] ip pim graceful-restart {helper-only | nsf [restart-time | stale-entry-time]} Parameters ipv6 helper-only nsf Enter this keyword to enable graceful-restart for IPv6 Multicast Routes. Enter the keyword helper-only to configure as a receiver (helper) only by preserving the PIM status of a graceful restart PIM neighboring router. Enter the keyword nfs to configure the Non-stop Forwarding capability. PIM-Sparse Mode (PIM-SM) | 1101