Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 638

www.dell.com | support.dell.com debug arp c e s View information on ARP transactions. Syntax debug arp [interface] [count value] To stop debugging ARP transactions, enter no debug arp. Parameters interface count value (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed by the slot/port information. • For the Management interface, enter the keyword managementethernet followed by the slot/port information. The slot range is 0-1 and the port range is 0. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the keyword count followed by the count value. Range: 1 to 65534 Command Modes EXEC Privilege Command History Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.3.1.0 Support 4094 VLANs on E-Series ExaScale (prior limit was 2094) Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Added the count option Defaults No default behavior or values Usage Use the count option to stop packets from flooding the user terminal when debugging is turned on. Information debug ip dhcp c e s Enable debug information for DHCP relay transactions and display the information on the console. Syntax debug ip dhcp To disable debug, use the no debug ip dhcp command. Defaults Debug disabled Command Modes EXEC Privilege 638 | IPv4 Routing