Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 904

www.dell.com | support.dell.com Version 7.6.1.0 Version 7.4.1.0 Introduced on C-Series Introduced on E-Series Usage LLDP must be enabled globally from CONFIGURATION mode, before it can be configured on an Information interface. This command places you in LLDP mode on the interface; it does not enable the protocol. When you enter the LLDP protocol in the Interface context, it overrides global configurations. When you execute the no protocol lldp from the INTERFACE mode, interfaces will begin to inherit the configuration from the global LLDP CONFIGURATION mode. show lldp neighbors c e s Display LLDP neighbor information for all interfaces or a specified interface. Syntax show lldp neighbors [interface] [detail] Parameters interface detail (OPTIONAL) Enter the following keywords and slot/port or number information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword gigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet followed by the slot/port information. (OPTIONAL) Enter the keyword detail to display all the TLV information, timers, and LLDP tx and rx counters. Defaults No default values or behavior Command Modes EXEC Privilege Command History Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Figure 31-1. show lldp neighbors Command Output R1(conf-if-gi-1/31)#do show lldp neighbors Loc PortID Rem Host Name Rem Port Id Rem Chassis Id Gi 1/21 R2 Gi 1/31 R3 GigabitEthernet 2/11 00:01:e8:06:95:3e GigabitEthernet 3/11 00:01:e8:09:c2:4a Usage Omitting the keyword detail displays only the remote chassis ID, Port ID, and Dead Interval. Information 904 | Link Layer Detection Protocol (LLDP)