Dell Force10 C150 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 60
boot change
View all Dell Force10 C150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
www.dell.com | support.dell.com • show bootvar • show default-gateway • show interface management ethernet Note: You cannot use the Tab key to complete commands in this mode. Note: The question mark (?) key to get help does not work in this mode. Instead, enter help. boot change c es Change the primary, secondary, or default FTOS boot configuration. Syntax boot change {primary | secondary | default} Parameters primary secondary default Enter the keyword primary to configure the boot parameters used in the first attempt to boot FTOS. Enter the keyword secondary to configure boot parameters used if the primary operating system boot selection is not available. Enter the keyword default to configure boot parameters used if the secondary operating system boot parameter selection is not available. The default location should always be the internal flash device (flash:), and a verified image should be stored there. Defaults Not configured. Command Modes BOOT_USER Command History Version 7.8.1.0 Introduced on S-Series Usage Information After entering the boot change keywords and selecting among parameters, above, press Enter. The software prompts you to enter the following: • The boot device (ftp, tftp, flash, slot0) (Note: tftp and flash are the only options available for the S-Series), image file name, IP address of the server containing the image, username and password (only for FTP) Note: When you enter a new parameter that extends beyond 80 characters, you cannot use the Backspace key to correct any mistakes. If you make a mistake, you must re-enter the parameter. Note: The IP address of the designated download port must be set before you execute this command. Otherwise, an error message will alert you that the configuration cannot proceed. See the command interface management ethernet ip address. Figure 4-1 shows the first field after you enter boot change primary. At this point: • Press Enter to accept the information already configured, or • Change that information. To do so, press the . (period) key and enter new information. After you enter the information, press Enter. 60 | BOOT_USER Mode