Dell Inspiron 16 5640 Owners Manual - Page 84
Removing the system board, System board - USB Type-C bracket with single screw
View all Dell Inspiron 16 5640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Figure 59. Removing the system board Steps 1. Remove the two (M2.5x5) screws that secure the right-display hinge to the palm-rest and keyboard assembly. 2. Open the right-display hinge at an angle of 90 degrees. 3. Disconnect the following cables on the system board: a. display cable (eDP) b. power-adapter port cable (DCIN) c. keyboard cable (KB) d. keyboard-backlight cable (BL) e. battery cable (BATT) f. touchpad cable (TP) g. speaker cable (SPK) h. fan cable (FAN) i. I/O-board cable (IO) 4. Remove the screw (M1.6x1.8) and the four (M2x3.5) screws that secure the system board to the palm-rest and keyboard assembly. NOTE: A USB Type-C bracket is secured to the system board with a single (M2x3.5) screw. The bracket is attached with the system board as a service part and must not be removed from the system board. Figure 60. System board - USB Type-C bracket with single screw 84 Removing and installing Field Replaceable Units (FRUs)