Dell Latitude XT2 XFR Service Manual - Page 39
Removing the Mini-Card
View all Dell Latitude XT2 XFR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
4.7.1 Dell™ Latitude™ XT2 XFR Service Manual Removing the Mini-Card 1. Follow the procedures in Before Working Inside Your XT2 XFR. 2. Remove the battery from the XT2 XFR. 3. Remove the memory and mini-card cover before continuing. 4. Depending on the type of wireless adapter installed, disconnect either two or three antenna cables from the mini-card. Each mini-card will have a label for the wire to be connected or disconnected from the adapter. WWAN, WLAN and WPAN mini-cards all have similar labeling. NOTE: There are five cables located under the memory door. Two enter the bay from the left side, three enter from the back center location. The table below explains where each cable would connect to for WLAN and WWAN devices. Most new WLAN and WWAN mini-cards available today have icons on their label that tells you which cable to connect to which antenna port. 1 BLACK (left side) - Connects to black labeled terminal on WLAN adapters 2 GREY (left side) - Connects to grey terminal on WWAN adapters 3 WHITE (center) - Connects to white terminal on WLAN adapters 4 WHITE/GREY (center) - Connects to white terminal on WWAN adapters 5 GREY (center) - Connects to grey terminal on WLAN adapters (If adapter is A/G/N capable) Page 39 of 94 Version A00-01