Dell PowerEdge M520 Dell PowerConnect M6220/M6348/M8024/M8024-k CLI Referen - Page 1163

exit-overflow-interval Use the exit-overflow-interval command in Router OSPFv3 Configuration mode to configure the exit overflow interval for OSPF. It describes the number of seconds after entering Overflow state that a router will wait before attempting to leave the Overflow State. This allows the router to originate non-default AS-external-LSAs again. When set to 0, the router will not leave Overflow State until restarted. Syntax exit-overflow-interval seconds no exit-overflow-interval • seconds - Exit overflow interval for OSPF (Range: 0-2147483647) Default Configuration 0 is the default value for seconds. Command Mode Router OSPFv3 Configuration mode User Guidelines This command has no user guidelines. Example The following example configures the exit overflow interval for OSPF at 100 seconds. console(config)#ipv6 router ospf console(config-rtr)#exit-overflow-interval 100 external-lsdb-limit Use the external-lsdb-limit command in Router OSPFv3 Configuration mode to configure the external LSDB limit for OSPF. If the value is -1, then there is no limit. When the number of non-default AS-external-LSAs in a router's link-state database reaches the external LSDB limit, the router enters OSPFv3 Commands 1163