Dell PowerEdge M520 Dell PowerConnect M6220/M6348/M8024/M8024-k CLI Referen - Page 567

minimum active uplinks Use the minimum active uplinks command to set the minimum number of uplinks to be active for the Group. For example, if the number of uplink ports in the group is 2 and the number of internal ports is 4. If the user sets the minimum active uplink ports to be 2, then both the uplink ports should be active; otherwise, all the internal ports in the Group will be brought down. By default, the minimum active uplinks for a Group is 1, which means at least one uplink port should be active for the Aggregator Group to be active. Syntax minimum active uplinks • number of uplinks - Minimum number of uplinks to be active for the Aggregator Group to be active. (Range: 1-4) Default Configuration This command has no default configuration. Command Mode Port Aggregator mode User Guidelines This command has no user guidelines. Example console(config)#port-aggregator group 2 console(config-aggregator-2)#minimum active uplinks 2 console(config-aggregator-2)# mtu disable Use the mtu disable command to set the mtu size to default (1518) on all the member ports in the aggregator group/zone. To set the mtu size to the maximum value (9216), use the no form of this command. Port Aggregator Commands 567