Dell PowerEdge M520 Dell PowerConnect M6220/M6348/M8024/M8024-k CLI Referen - Page 923

Using this command, the administrator may manually configure a single, global default gateway. The switch installs a default route for a configured default gateway with a preference of 253, making it more preferred than the default gateways learned via DHCP, but less preferred than a static default route. The preference of these routes is not configurable. The switch installs a default route for the default gateway whether or not routing is globally enabled. When the user displays the routing table (e.g. show ip route), the display identifies the default gateway, if one is known. Use the show ip route static all command to display the configured static routes and preferences. Example The following example identifies the next-hop-ip and a preference value of 200. console(config)#ip route default 192.168.10.1.200 ip route distance Use the ip route distance command in Global Configuration mode to set the default distance (preference) for static routes. Lower route preference values are preferred when determining the best route. The ip route and ip route default commands allow optional setting of the distance of an individual static route. The default distance is used when no distance is specified in these commands. Changing the default distance does not update the distance of existing static routes, even if they were assigned the original default distance. The new default distance are applied to static routes created after invoking the ip route distance command. Syntax ip route distance integer no ip route distance integer • integer - Specifies the distance (preference) of an individual static route. (Range 1-255) Default Configuration Default value of distance is 1. IP Routing Commands 923