Dell PowerEdge M520 Dell PowerConnect M6220/M6348/M8024/M8024-k CLI Referen - Page 1591

Command Mode Global Configuration mode User Guidelines This command has no user guidelines. Example The following example sets the mode to Stack Global Config. console(config)#stack console(config-stack)#stack-port NOTE: All of the stack-port commands in Stack Configuration mode are not supported by the PCM8024 and PCM8024-k switches.Use the stack-port command in Stack Configuration mode to configure Stack ports as either Stacking ports or as Ethernet ports. This command is used to configure CX-4 ports to be either stacking or Ethernet ports. By default, CX-4 ports are Ethernet ports. Syntax stack-port tengigabitethernet unit/slot/port {ethernet | stack} Default Configuration By default, these ports are configured as stacking ports. Command Mode Stack Configuration mode User Guidelines The clear config command will not change the stacking port mode. Only the stack-port command can change the operating mode of the stacking port and it only takes effect after a reboot when changing between stacking and Ethernet mode. If this command is used with a CX-4 module, the ports will be forced to Ethernet mode upon reboot. Use the show switch stack-port command to display configuration and status of stacking ports. System Management Commands 1587