Dell PowerEdge M520 Dell PowerConnect M6220/M6348/M8024/M8024-k CLI Referen - Page 429

Default Configuration The default timer values are as follows: • Join timer - 20 centiseconds • Leave timer - 60 centiseconds • Leaveall timer - 1000 centiseconds Command Mode Interface Configuration (gigabitethernet, port-channel, tengigabitethernet) mode User Guidelines The following relationships for the various timer values must be maintained: • Leave time must be greater than or equal to three times the join time. • Leaveall time must be greater than the leave time. Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set differently on Layer 2-connected devices, the GARP application will not operate successfully. The timer_value setting must be a multiple of 10. Example The following example sets the leave timer for port 1/0/8 to 90 centiseconds. console (config)# interface gigabitethernet 1/0/8 console (config-if-1/0/8)# garp timer leave 90 gvrp enable (global) Use the gvrp enable (global) command in Global Configuration mode to enable GVRP globally on the switch. To disable GVRP globally on the switch, use the no form of this command. Syntax gvrp enable no gvrp enable GVRP Commands 429