Dell PowerEdge M520 Dell PowerConnect M6220/M6348/M8024/M8024-k CLI Referen - Page 1170

User Guidelines Normally, the network type is determined from the physical IP network type. By default all Ethernet networks are OSPF-type broadcast. Similarly, tunnel interfaces default to point-to-point. When an Ethernet port is used as a single large bandwidth IP network between two routers, the network type can be point-to-point since there are only two routers. Using point-to-point as the network type eliminates the overhead of the OSPF designated router election. It is normally not useful to set a tunnel to OSPF network type broadcast. Example The following example changes the default OSPF network type to point-topoint. console(config)#interface vlan 15 console(config-if-vlan15)#ipv6 ospf network point-topoint ipv6 ospf priority Use the ipv6 ospf priority command in Interface Configuration mode to set the OSPF priority for the specified router interface. Use the no form of the command to return the priority to the default value. Syntax ipv6 ospf priority number-value no ipv6 ospf priority • number-value - Specifies the OSPF priority for the specified router interface. (Range: 0-255) A value of 0 indicates that the router is not eligible to become the designated router on this network. Default Configuration 1, the highest router priority, is the default value. Command Mode Interface Configuration (VLAN, Tunnel, Loopback) mode. 1170 OSPFv3 Commands