Dell PowerEdge M520 Dell PowerConnect M6220/M6348/M8024/M8024-k CLI Referen - Page 185

Command Mode Tunnel Loopback Access Method Command Prompt Exit or Access Previous Mode From Global Configuration mode, use the interface tunnel command. Or, use the abbreviation interface tu. console(config-tunneltunnel- To exit to Global id)# Configuration mode, use the exit command, or press + to Privileged EXEC mode. From Global console(config- configuration mode, loopbackloopback-id)# use the interface loopback command. Or, use the abbreviation interface lo. To exit to Global Configuration mode, use the exit command, or press + to Privileged EXEC mode. Starting the CLI To begin running the CLI, perform the following steps: NOTE: This procedure is for use on the console line only. NOTE: The Easy Setup Wizard is available only when the system is in default state with no user configuration saved previously. 1 Start the switch and wait until the startup procedure is complete and the User EXEC mode is entered. The prompt console> is displayed. 2 Configure the switch using the Easy Setup Wizard and enter the necessary commands to complete the required tasks. 3 When finished, exit the session with the quit or exit command. The switch can be managed over a direct connection to the switch console port or through a Telnet connection. If access is through a Telnet connection, the switch must have a defined IP address, corresponding management access granted, and a connection to the network. Using the CLI 185