Dell PowerEdge R440 EMC Installation and Service Manual 1 - Page 107
Optional IDSDM or vFlash module, Removing the optional IDSDM or vFlash card
![]() |
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Figure 78. Installing the MicroSD card Next steps Follow the procedure listed in After working inside your system. Optional IDSDM or vFlash module Removing the optional IDSDM or vFlash card Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. If you are replacing the IDSDM/vFlash card, remove the MicroSD cards. NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal. Steps 1. Locate the IDSDM/vFlash connector on the system board. To locate IDSDM/vFlash connector, see the System board jumpers and connectors section. 2. Holding the pull tab, lift the IDSDM/vFlash card out of the system. Installing and removing system components 107
![](/manual_guide/products/dell-poweredge-r440-emc-installation-service-manual-4fc47c7/107.png)