Dell PowerEdge R440 EMC Installation and Service Manual 1 - Page 70
Removing a 2.5-inch drive from a 3.5-inch drive adapter
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Figure 31. Installing a drive blank Next steps If removed, install the front bezel. Removing a 2.5-inch drive from a 3.5-inch drive adapter Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Remove the 3.5-inch drive adapter from the 3.5-inch drive carrier. NOTE: A 2.5-inch drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch drive carrier. Steps 1. Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5-inch drive adapter. 2. Remove the 2.5-inch drive from the 3.5-inch drive adapter. Figure 32. Removing a 2.5 inch drive from a 3.5-inch drive adapter Next steps Install a 2.5-inch drive into a 3.5-inch drive adapter. 70 Installing and removing system components