Dell PowerEdge R440 EMC Installation and Service Manual 1 - Page 112
Installing the hard drive backplane
![]() |
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Figure 86. 10 x 2.5 backplane with expander 1. SAS_A connector 3. backplane power cable connector 5. SAS_C connector 2. backplane signal cable connector 4. SAS_B connector Installing the hard drive backplane Prerequisites Follow the safety guidelines listed in Safety instructions. NOTE: The procedure to install the backplane is similar for all backplane configurations. Steps 1. Align the slots on the backplane with the hooks on the system. 2. Lower the hard drive backplane until the blue release tabs snap into place. 3. If your backplane has an expander board, then tighten the captive screws to secure the expander board to the system. Figure 87. Installing the hard drive backplane Next steps 1. Connect all the cables to the backplane. 112 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r440-emc-installation-service-manual-4fc47c7/112.png)