Dell PowerEdge R440 EMC Installation and Service Manual 1 - Page 127
Installing the left control panel
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Figure 106. Removing left control panel 4. Holding by the sides, remove the left control panel assembly away from the system. Next steps Install the left control panel. Installing the left control panel Prerequisites Follow the safety guidelines listed in Safety instructions. Steps 1. Route the control panel cable through the side wall of the system. 2. Align the left control panel assembly with the control panel slot on the system and place the assembly in the slot on the system. 3. Connect the control panel cable to the system board connector. 4. Using Phillips #1 screwdriver, install the screws that secure the cable cover to the system. Figure 107. Installing the cable cover Next steps 1. Follow the safety guidelines listed in Safety instructions. 2. Install the air shroud. 3. Install the internal PERC riser. Installing and removing system components 127